Tim Suddard
Tim Suddard Publisher
12/26/12 12:12 p.m.
feature_image

While rebuilding our transmission we got into a discussion with the folks at Mini Mania about final driver ratio selection. The standard ratio for the 1275cc Cooper S was 3.44:1. And while our car still had this stock, standard ratio, Mini Mania owner, Don Racine, suggested that if our intended use for the finished car would be some highway use and higher speed, long distance rally work, then we may be happier with a higher (lower numerically) final drive. He pointed out that with the stock 3.44:1 final drive ratio, a Mini Cooper is straining and turning very high rpm at today’s legal highway speeds.

As we had tweaked our head a bit and had a little hotter cam, our engine would be good for another 5-10 percent more horsepower. So we felt we would still be able to come off the line even with the higher final ratio.

Generally, we like to test everything for ourselves, but we had no desire to take apart the gearbox twice, and Racine and his crew have many years of Mini experience, so we trusted them. He recommended a 3.10:1 final drive as a good compromise for overall drivability.

There are a few tricks needed to install the physically larger ring gear, which we will get into when we start our story series in the May issue of Classic Motorsports. You can pick up that issue on newsstands in early April, or subscribe today and guarantee you don’t miss the details on this project car build.

It was an itsy bitsy, teeny-weeny rally-winning project Mini. Subscribe to Classic Motorsports and get them in your mailbox.

Read the rest of the story

GregWClassic
GregWClassic New Reader
1/30/13 11:54 a.m.

You did not remove much more then casting flash did you?

Our Preferred Partners
wFTR830dDCKDdTzfqDQaWECAEg3E8pKMBI0wOyDlJ6DtFsRT4Ww9qtGUbao0yFQc