Running Restoration of a Logan Lathe

Toyman01 (Forum Supporter) said:

I'm not super familiar with the Logan, but I run a serpentine automotive belt on my South Bend 9". I cut the leather belt off, measured it and bought a serpentine belt the correct width and length. 

I've read similar with good results. The guy said he just used superglue to attach it with good results, but your endless idea sounds much better, if tougher to install (on a complete lathe, unlike where you're going).

My Logan uses a v belt. I had to cut it but I should still have it around to measure if needed.

I got mixed up by all the pictures. Mine is actually the same as Djsilver's above. It uses a flat belt.