dyintorace
dyintorace UltimaDork
2/14/24 8:52 a.m.

I am in need of a pair of these. Does anyone happen to have a set they'll let go for cheap? Like Challenge money cheap?

If not, would these work well enough?

Amazon headers

GM LS Swap Cast Iron Exhaust Manifold LS1 LS2 LS3 4.8L 5.3L 6.0L Street Rod (DM-3303)

Dusterbd13-michael
Dusterbd13-michael MegaDork
2/14/24 8:54 a.m.

Take a look back in my Nascar thread Period I bought a set of the cheap stainless Block hugger headers For it That were like 70 bucks That fit amazingly tight and look to have about the same Outlet point as the ones you linked

SV reX
SV reX MegaDork
2/14/24 8:56 a.m.

Something is happening at casa dyintorace...smiley

dyintorace
dyintorace UltimaDork
2/14/24 2:38 p.m.
Dusterbd13-michael said:

Take a look back in my Nascar thread Period I bought a set of the cheap stainless Block hugger headers For it That were like 70 bucks That fit amazingly tight and look to have about the same Outlet point as the ones you linked

Will do. Thanks for the lead.

SV reX said:

Something is happening at casa dyintorace...smiley

Maybe...

dyintorace
dyintorace UltimaDork
2/14/24 3:27 p.m.

@dusterbd13-michael - I found where you bought ebay headers on this page of that thread. Are those the ones? Any idea who you bought them from?

MrJoshua
MrJoshua UltimaDork
2/14/24 3:40 p.m.
dyintorace said:

@dusterbd13-michael - I found where you bought ebay headers on this page of that thread. Are those the ones? Any idea who you bought them from?

 

You may get some interference with those and the motor mount on your setup. It might clear, but it will be close. Of course the rear dump manifolds may find the firewall so you may have to order both and see?

81cpcamaro
81cpcamaro SuperDork
2/14/24 4:20 p.m.

Those Amazon headers are basically a copy of the Hooker Blackheart exhaust manifolds for S10 LS swaps ($320 for the Hooker ones). The 5th gen Camaro ones are similar, but the outlets tend to be more outward and may interfere.

Keith Tanner
Keith Tanner MegaDork
2/14/24 4:31 p.m.

Those look like the headers that show up on LS3 crates since the Corvette went LT. That makes them Camero. 

Streetwiseguy
Streetwiseguy MegaDork
2/14/24 4:56 p.m.

Not challenge friendly, but the cast iron Hookers are a very nice piece. 

It's the outlet that is the issue with cheap truck ones.  The won't even go into a 67 Camaro, which has lots of width compared to lots of things. 

Camaro manifolds on ebay?

You'll need to log in to post.

Our Preferred Partners
N6nldWvdyFCIhksnu7abnFWasArjmqQJ4vxvzDh3q3PPBoOhPxG3st9nCyvvMSpJ