9/5/17 6:44 p.m.

Hello all this is my first post here. i am in the process of rolling in new main bearings on my 626. I used a screwdriver to tap the bearings in and I may have hit the end of the bearing a just a little to hard. Hard enough to leave a slight impression in the end of the bearing where it will crush against the other half in the cap. 

Am I wasting my time putting this back together or do you guys think it will make no difference? I Really don't want to put it together if I'm just gonna be take it back apart. 

Advice is much appreciated!

Mezzanine Dork
9/8/17 5:49 p.m.

Pictures would help, but I'm guessing it will be ok. Post up a pic or two of the damaged area and another with the cap assembled so we can see what we're dealing with.

JamesMcD SuperDork
10/14/17 12:03 a.m.

Hello,  I can't address your question,  but do you have a 626 turbo?  I own four of them (at my house)! And I have a mx6 turbo in storage. I'm happy to see another 626 person here. 

pres589 PowerDork
10/14/17 1:39 a.m.

Can you feel the impression? How noticeable is it? 

Our Preferred Partners