Complete, or near it, 4.6 5spd swap *3650*

This is for a 3650 5spd out of an '08 GT. Transmission is ready to go to the best of my knowledge. Car had approx. 50k miles on it. I planned a project with this, and its changing directions some.

What do you get?

TR-3650 Transmission Stock Shifter Stock Flywheel Clutch this is used, it still has life left on it Hard lines & Hydraulic Throwout bearing Pedals Driveshaft stock mustang 2 piece

This will give you just about all you need to swap into another 4.6 vehicle with a 6 bolt crank. The only question if you put it in something other than a 05-10 mustang to make it a 5spd is if you needed to get a different driveshaft.

Asking for $500 for all of it or make me an offer. Located in Spring, TX

Want is strong, but pockets is weak.

This would work better than the NV3500 for my 4.8L swap . . . .

Sold

Strike_Zero wrote: Want is strong, but pockets is weak. This would work better than the NV3500 for my 4.8L swap . . . .

isnt the bellhousing integrated on these? i think it was on my t45 that i had for my crown vic.

Bob Hanlon has a replacement front cover that can use 621 bellhousing to mount it to SBC. Same bellhousing you can use to mount 4speeds to LSx . . .