Hello all,
When I was building my race car I used a quick release device for my steering wheel which did not allow me to use my horn button on my Momo steering wheel. I decided to make an aluminum mold and made a Carbon Fiber block-off plate to give it a more finished look. I did a run of 15 of these to use up all of the materials and I am selling off the extra ones.
If anyone is interested, please email (paypal) me at Compositechef@gmail.com
$39.99 shipped to the 48 states. Please send a photo when you get it if you get one, thanks!
bgkast
UberDork
11/20/13 12:05 p.m.
This is much cooler than I was expecting. Too bad my project is too far off from needing it (don't even have a steering wheel yet).
Thanks guys. As I said, I made this because I didnt want my otherwise nice looking race car to have the hardware/etc of the quick release showing through. Someone just bought one from here for their Miata!
They will be around and I can always make more so check back when the time comes that you will need one!
Because it's made of carbon fiber, it's lighter than no button at all! 
I'll post pics when I get mine...
yamaha
PowerDork
11/20/13 3:20 p.m.
I still have to get a wheel......i'll check back in when I do.
Keith, your plate shipped on Friday. Thank you again. Please send a photograph to the same email address when you get it. Thanks!
Sold a few of these but still more available!
In reply to JoshJenny:do you
Still have any for sale?
These plates are still available! I have made a few upgrades to them and they are looking really sharp!
Good, because I need a couple more. I'll be in touch next week.
Still got some? I'm interested!
