Well this thread had me in a panic for a bit. 
After much maths, my B4800 plans continue. Glad I didn't cut any explorer axle spring perches yet!
Well this thread had me in a panic for a bit.
After much maths, my B4800 plans continue. Glad I didn't cut any explorer axle spring perches yet!
In reply to bluej:
Me too, the other night I ran the numbers for three builds just to make sure.
Since mine's not fully assembled, I think I'll wait until it is together, then calculate where it'll sit with 14" tires and 2" spacers up front. For all I know, at that point I may be able to meet the 1:1 rule by having a full tank of gas.
eastsidemav wrote: Since mine's not fully assembled, I think I'll wait until it is together, then calculate where it'll sit with 14" tires and 2" spacers up front. For all I know, at that point I may be able to meet the 1:1 rule by having a full tank of gas.
If you're close just crank in about 3 inches of toe out for going thru tech...
chop the top?
pushrod36 wrote: chop the top?
Only if I remove a few vertebrae, too 
You'll need to log in to post.
