Tim Suddard
Tim Suddard Publisher Emeritus
4/24/24 10:28 a.m.
feature_image

Our next project on our Sprite’s interior was to deal with the shift boot. Putting a five-speed in place of the original four-speed caused a problem: The hole in the metal hump that surrounds the shifter simply didn’t allow enough room to move the lever into fifth.

[How to mate a…

Read the rest of the story

jkevin
jkevin New Reader
4/24/24 11:22 a.m.

I have been using a generic Dorman CV joint boot from Advance Auto for years!

jgrewe
jgrewe Dork
4/24/24 3:12 p.m.

I went the other direction and cut a section out of the metal piece to lower the top. The hole and boot are the stock, I was able to move the the boot closer to the pivot point of the shifter. I took about an inch out of it IIRC.

You'll need to log in to post.

Our Preferred Partners
GS2XcOBJXwYzP2fNThiPZ1lpaDoKKx4QrW7lgBndV7vJBUCXmJ2BQUQeP0vqE3yN